|
|
SE-R/G20/NX Clutch
|
JGY-DRAG-se-r Clutch
Hey, here we go again, brought it to the market. This kid will hold over 500ft/lbs of torque. We run it in our drag car. Surprising very little chatter and wow does it grab that power. This is for the serious
horsepower FWD SR car. $399
JGY Lightweight flywheel. Steel construction. 11 pounds, and better suited for higher HP powered cars 350 or more, this is what we run in our drag car - $259 ****Also, our flywheels don't trigger your check engine light, that's right, we use the correct number of teeth on the ring gear, so that crank angle sensor sees what it should
JGY Lightweight flywheel. Steel construction. 8.8 pounds, and better suited for street cars and racers, this is the flywheel for 90% of our consumers -$269 ****Also, our flywheels don't trigger your check engine light, that's right, we use the correct number of teeth on the ring gear, so that crank angle sensor sees what it should
|
JGY-STREET-se-r Sprung 6 puck disk, 390ft/lb of torque - $309
This is our "go to" clutch. We use it for JDM motor installs to Bluebird installs, to upgraded turbo installs. We take great pride in this clutch. This is probably one of the best clutches on the market for the Se-r.
Wow, didn't think we could bring another? well we did, this thing is awesome, and is priced even better than the one above. $289 and holds 290ft/lbs of torque. If you want a replacement clutch with a marginally stronger pedal, long lasting clutch, then here you go.
|
|